Any suggestions appreciated.Īnyone is welcome to use the blocks contained in the attached drawing. See the attached file to see where I am as of today. I could also set a max number of contacts to be 8. In the pinlist I could setup a '4,PORT 1,*Port 1 4,PORT 2,*Port 2 etc.'. I am looking for a way to create a parent block that has 8 connections (ports) that I can use my RJ45 symbol (child) to carry the port information.Ĭould I treat the Enet switch like a relay and the ports like the contacts.

The problem is I don't want multiple parents (8) for one ethernet switch. It would be best if each port were a parent so the RJ45 (child) symbol would carry the port number when it is placed next to the drive. I currently have everything figured out except how to handle the ports in the ethernet switch. This will allow me to see IP information at the ethernet switch for each port as well allow me to surf the parent or sibling blocks. I can then connect the two RJ45 blocks via a cable. I also want to display a RJ45 symbol at the drive that will be a sibling of the ethernet switch and carry port number information. As part of the connection drawing I want to show the IP data (RATING10, 11 &12 ) from the drive at the ethernet switch in the form of a RJ45 symbol. Now that the drive setup is ready I need to show the connection to the ethernet switch. The Hdr2_Enet block then obtains the RATING10, 11 &12 information from the parent. I also have a Hdr2_Enet that is the ethernet module that is plugged into the drive. I then use a Hdr2_XXX to be the control connections for the drive. This block is loaded with RATING10, 11 &12 that represent the ethernet address, subnet and gateway. Here is a brief breakdown of how to read a symbol. Currently I use a block Hdr1_power that is used in the 3 phase part of the drawing. Symbols show the methods of actuation, the number of positions, the flow paths and the number of ports. I am looking at taking the connections a step further.

2 way switch symbol autocad